Table of Contents
Advertisement
6. Connect the 0 S termination to the APC-7 R
NNNNNNNNNNNNNN
7. Press
OPEN .
After an OPEN calibration sequence of about 20 seconds, the
underlined.
8. Disconnect the 0 S termination.
9. Connect the 0
termination on the APC-7 R
3-8
Basic Measurement Procedures
Figure 3-5.
Figure 3-7.
Figure 3-6.
connector as shown in Figure 3-7.
NNNNNNNNNNNNNN
OPEN softkey label is
connector as shown in Figure 3-8.
Advertisement
Table of Contents
