Connecting The Apc-3.5 To 7Mm Adapter - Agilent Technologies 4286A User Manual

6.
Further tighten the screws while holding the test head with your hand to completely
secure the head in place.
7.
Place the xture stand with its bottom surface down.

Connecting the APC-3.5 to 7mm Adapter

1. Check that the connector sleeve is fully extended.
2. Connect APC-3.5 to 7mm adapter to the test head connector through the hole on top of the
xture stand.
3. Tighten the adapter nut to secure this adapter in place.
2-10 Installation and Set Up Guide