Setting Up Handler Interface - Agilent Technologies 4286A User Manual

NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press UPPER LIMIT .
Enter upper limit value (14nH).
NNNNNNNNNNNNNN
Press DONE to complete the editing of this segment.
5. Segment 3
NNNNNNNNNNN
Press ADD to edit the new segment.
Enter stimulus, lower limit, and upper limit values in the same manner above.
NNNNNNNNNNNNNN
Press DONE to complete the editing of this segment.
6. Press
NNNNNNNNNNNNNN
DONE to complete the editing of the primary parameter limit table.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Then, press EDIT SEC LIMIT to edit the secondary parameter limit table.
1. Segment 1
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press LOWER LIMIT .
Enter lower limit value (100.0).
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Press UPPER LIMIT .
Enter upper limit value (1G).
NNNNNNNNNNNNNN
Press DONE to complete the editing of this segment.
2. Segment 2,3
Enter lower and upper limit values and press
segment in the same manner as segment 1.

Setting up Handler Interface

1. Set up the handler interface board. See \Setting up Handler Interface Board" for the set up
procedure.
2. Press
, and then
4 Test Setup 5
3. Press
NNNNNNNNNNNNNNNNNNNN NNNNNNNNNNNNNNNNNNNN
MODE 1 or
When you perform limit test, select the signal pattern from either Mode 1 or Mode 2. The
output for the interface varies depending the mode used as follows.
Outputs overall results of comparison for limit test.
NNNNNNNNNNNNNNNNNNNN
MODE 1
Outputs results for each segment.
NNNNNNNNNNNNNNNNNNNN
MODE 2
See \Setting up Handler Interface Board" for details abount the mode.
4. Press
NNNNNNNNNNNNNNNNNNNN
RETURN .
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
HANDLER IF .
MODE 2 .
NNNNNNNNNNNNNN
DONE to complete the editing of this
4286A with Chip Handler 4-5