Table of Contents
Advertisement
NNNNNNNNNNNNNNNNN
10. Press
SHORT .
After a SHORT calibration sequence of about 20 seconds, the
underlined.
11. Disconnect the 0
termination.
12. Turn only the APC-7 R
13. Verify that the connector sleeve is retracted fully as shown in Figure 3-10.
14. Connect the 50
termination on the APC-7 R
Figure 3-8.
connector nut of the 50
termination as shown in Figure 3-9.
Figure 3-9.
NNNNNNNNNNNNNNNNN
SHORT softkey label is
Figure 3-10.
connector as shown in Figure 3-11.
Basic Measurement Procedures
3-9
Advertisement
Table of Contents
