Table of Contents
Advertisement
10 Operation
10-2-2 Turning ON the Power Supply
Turn ON the control circuit power after you conduct the pre-power-ON checking.
It is indifferent whether you turn On or OFF the main circuit power.
10-2-3 Checking the Displays
7-Segment Display
The 7-segment display is on the front panel.
When the power is turned ON, it shows the node address that is set by the rotary switches. Then the
display changes according to the setting of the LED Display Selection (3700 hex).
An error code is displayed if an error occurs. A warning code is displayed if a warning occurs.
Node Address Display
10 - 6
Control power ON
A
To
on the next page
G5-series Linear Motors/Servo Drives With Built-in EtherCAT Communications
Fully OFF
Fully ON
"nA" (node address, approx. 0.6 s)
Rotary switch setting
(upper digit (×10) = 0, lower digit (×1) = 3)
(It lasts for the period set in the Power ON
Address Display Duration Setting (3701 hex).)
Advertisement
Table of Contents
Troubleshooting
