Lenovo ThinkSystem SR675 V3 User Manual page 111

• Make sure to adopt one of the supported configurations listed in
order" on page 49.
• Memory modules are sensitive to static discharge and require special handling. Refer to the standard
guidelines at "Handling static-sensitive devices" on page
– Always wear an electrostatic-discharge strap when removing or installing memory modules.
Electrostatic-discharge gloves can also be used.
– Never hold two or more memory modules together so that they do not touch each other. Do not stack
memory modules directly on top of each other during storage.
– Never touch the gold memory module connector contacts or allow these contacts to touch the outside
of the memory module connector housing.
– Handle memory modules with care: never bend, twist, or drop a memory module.
– Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid
metals may damage the memory modules.
– Do not insert memory modules while holding packages or passive components, which can cause
package cracks or detachment of passive components by the high insertion force.
Important: Remove or install memory modules for one processor at a time.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/tw/en/products/servers/thinksystem/sr675v3/7d9q/downloads/
driver-list/ to see the latest firmware and driver updates for your server.
• Go to "Update the firmware" on page 217
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Attention: Make sure to remove or install memory module 20 seconds after disconnecting power cords from
the system. It allows the system to be completely discharged of electricity and safe for handling memory
module.
Step 1. Touch the static-protective package that contains the memory module to any unpainted surface on
the outside of the server. Then, take the memory module out of the package and place it on a
static-protective surface.
Step 2. Locate the required memory module slot on the system board assembly.
Note: Ensure that you observe the installation rules and sequence order in
installation rules and order" on page
for more information on firmware updating tools.
.
49.
"Memory module installation rules and
48:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5 Hardware replacement procedures
"Memory module
103