Lenovo ThinkSystem SR675 V3 User Manual page 183

Figure 140. E3.S drive backplane bracket installation
Step 2. Install the E3.S drive backplane module.
a. Align the tabs on the bottom of the backplane module with the slots on the drive cage, and
insert them into the slots.
b. Push the top of the backplane module toward the drive cage until it clicks into place.
c. Fasten the two thumbscrews to secure the backplane module to the drive cage.
Figure 141. E3.S drive backplane module installation
After you finish
1. Reinstall the E3.S drive cage assembly. See
2. Reconnect the power and signal cables to the E3.S drive backplane.
3. Reinstall the E3.S hot-swap drives or drive bay fillers (if any) into the drive bays. See
S hot-swap drive" on page
4. Complete the parts replacement. See
"Install the E1.S / ES.3 drive cage assembly" on page
166.
"Complete the parts replacement" on page 194.
.
Chapter 5 Hardware replacement procedures
178.
"Install an E1.S / E3.
175