Observable Problems - Lenovo ThinkSystem SR675 V3 User Manual

Cannot wake server using Wake on LAN
Complete the following steps until the problem is resolved:
1. If you are using the dual-port network adapter and the server is connected to the network using Ethernet
5 connector, check the system-error log or XCC system event log (see
sure:
a. Fan 3 is running in standby mode, if Emulex dual port 10GBase-T embedded adapter is installed.
b. The room temperature is not too high (see
c. The air vents are not blocked.
d. The air baffle is installed securely.
2. Reseat the dual-port network adapter.
3. Turn off the server and disconnect it from the power source; then, wait 10 seconds before restarting the
server.
4. If the problem still remains, replace the dual-port network adapter.
Could not log in using LDAP account with SSL enabled
Complete the following steps until the problem is resolved:
1. Make sure that the license key is valid.
2. Generate a new license key and log in again.

Observable problems

Use this information to solve observable problems.
• "Server hangs during the UEFI boot process" on page 250
• "The server immediately displays the POST Event Viewer when it is turned on" on page 251
• "Server is unresponsive (POST is complete and operating system is running)" on page 251
• "Server is unresponsive (POST failed and cannot start System Setup)" on page 251
• "Voltage planar fault is displayed in the event log" on page 252
• "Unusual smell" on page 252
• "Server seems to be running hot" on page 252
• "Cannot enter legacy mode after installing a new adapter" on page 252
• "Cracked parts or cracked chassis" on page 253
Server hangs during the UEFI boot process
If the system hangs during the UEFI boot process with the message UEFI: DXE INIT on the display, make sure
that Option ROMs were not configured with a setting of Legacy. You can remotely view the current settings
for Option ROMs by running the following command using the Lenovo XClarity Essentials OneCLI:
onecli config show EnableDisableAdapterOptionROMSupport --bmc xcc_userid:xcc_password@xcc_ipaddress
To recover a system that hangs during the boot process with Legacy Option ROM settings, see the following
Tech Tip:
https://datacentersupport.lenovo.com/solutions/ht506118
ThinkSystem SR675 V3 User Guide
250
"Specifications" on page
"Event logs" on page 225), make
3).