Lenovo ThinkSystem SR675 V3 User Manual page 25

Table 3. Components on the front view with 6x E1.S 5.9mm drives
EDSFF drive cage cover
1
Front operator panel
2
Drive activity LED (green)
3
Drive status LED (yellow)
4
EDSFF drive cage cover
1
The 8-DW GPU Model servers should always operate with the EDSFF drive cage cover installed to the
chassis.
Front operator panel
2
For more information about the front operator panel, see
3 Drive activity LED (green)
Each hot-swap drive comes with an activity LED. When this LED is flashing, it indicates that the drive is in
use.
4 Drive status LED (yellow)
The drive status LED indicates the following status:
• The LED is lit: the drive has failed.
• The LED is flashing slowly (once per second): the drive is being rebuilt.
• The LED is flashing rapidly (three times per second): the drive is being identified.
5 PCIe slot 3-10
Install PCIe adapters, particularly GPUs to these slots. These PCIe slots support the following configuration:
• PCIe Gen5 x16, FH/FL
6 PCIe slot 1-2
Install PCIe adapters, particularly network adapters to these slots. These PCIe slots support the following
configuration:
• PCIe Gen5 x16, FH/FL
7 E1.S 5.9mm hot-swap drive bays (0 to 5)
Install E1.S 5.9mm hot-swap drives to these bays. See
for more information.
PCIe slot 3-10
5
PCIe Slot 1-2
6
E1.S 5.9mm hot-swap drive bays (0 to 5)
7
"Front operator panel LEDs" on page
"Install an E1.S / E3.S hot-swap drive" on page 166
Chapter 2
227.
.
Server components
17