2.5-Inch Drive Cage Assembly Replacement - Lenovo ThinkSystem SR675 V3 User Manual

Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Align the tabs on the bottom of the 2.5-inch drive backplane with the slots on the drive cage, and
insert the tabs into the slots.
Step 2. Push the top of the backplane toward the drive cage until it clicks into place.
Figure 123. 2.5-inch drive backplane installation
After you finish
1. Reinstall the 2.5-inch drive cage assembly. See
2. Reconnect the power and signal cables to the 2.5-inch drive backplane.
3. Reinstall the 2.5-inch hot-swap drives or drive bay fillers (if any) into the drive bays. See
inch hot-swap drive" on page
4. Complete the parts replacement. See

2.5-inch drive cage assembly replacement

Follow instructions in this section to remove and install the 2.5-inch drive cage assembly.
Remove the 2.5-inch drive cage assembly
Follow instructions in this section to remove the 2.5-inch drive cage assembly.
About this task
and "Safety inspection checklist" on page 46
.
"Install the 2.5-inch drive cage assembly" on page
157.
"Complete the parts replacement" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5 Hardware replacement procedures
to ensure that you
162.
"Install a 2.5-
194.
161