Power Supply Unit Replacement - Lenovo ThinkSystem SR675 V3 User Manual

About this task
Attention: Read "Installation Guidelines" on page 45
that you work safely.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Align the connector on the power distribution board with that on the system board assembly with
the two power supply connectors facing the power supply bays; then, press the power distribution
board into the connector until it is fully seated.
Step 2. Fasten the three screws to secure the power distribution board to the system board assembly.
Figure 90. Power distribution board installation
After you finish
1. Reinstall the power supply units. See
2. Complete the parts replacement. See

Power supply unit replacement

Follow instructions in this section to remove or install a power supply unit.
Remove a power supply unit
Follow instructions in this section to remove a power supply unit.
About this task
.
"Install a power supply unit" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
Chapter 5 Hardware replacement procedures
to ensure
124.
194.
123