Lenovo ThinkSystem SR675 V3 User Manual page 120

2. To replace the PCIe adapter, see
3. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Remove PCIe riser 1 installed with serial port module
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Disconnect the cables that are connected to the PCIe riser and the PCIe adapter.
Step 2. If the PCIe riser 2 is installed, remove it from the chassis. See
port module" on page
Step 3. Remove the PCIe riser 1 installed with serial port module.
a. Disconnect the serial port cable from the system board assembly.
b. Unfasten the thumbscrew on the PCIe riser.
c. Lift the PCIe riser out of the chassis.
Figure 79. PCIe riser 1 removal (with serial port module)
After you finish
1. If no PCIe riser is going to be installed to the chassis, install a riser filler into the chassis. See
PCIe riser" on page
2. To replace the PCIe adapter, see
3. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
ThinkSystem SR675 V3 User Guide
112
"Remove a PCIe adapter" on page
"Remove the top cover" on page
111.
115.
"Remove a PCIe adapter" on page
113.
154.
"Remove a PCIe riser without serial
113.
"Install a