Lenovo ThinkSystem SR675 V3 User Manual page 168

• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove all of the 2.5-inch hot-swap drives and the drive bay fillers (if any) from the drive bays.
See "Remove a 2.5-inch hot-swap drive" on page
surface.
c. Disconnect the power and signal cables from the 2.5-inch drive backplane.
d. Remove the 2.5-inch drive cage assembly. See
page 161.
Step 2. Remove the 2.5-inch drive backplane.
a. Lift and hold the two retention latches on the top of the 2.5-inch drive cage.
b. Rotate the backplane from the top to disengage it from the retention latches.
c. Carefully lift the backplane out of the server.
Figure 122. 2.5-inch drive backplane removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 2.5-inch drive backplane
Follow instructions in this section to install the 2.5-inch drive backplane.
About this task
ThinkSystem SR675 V3 User Guide
160
"Remove the server from rack" on page
.
"Remove the top cover" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
154.
156. Place the drives on a static protective
"Remove the 2.5-inch drive cage assembly" on
54.