Lenovo ThinkSystem SR675 V3 User Manual page 113

Step 3. Install the memory module into the slot.
a. Gently open the retaining clip on each end of the memory module slot.
b. Align the memory module with the slot, and gently place the memory module on the slot
with both hands.
c. Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
Attention:
• To avoid breaking the retaining clips or damaging the memory module slots, open and close
the clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module
has not been correctly inserted. In this case, open the retaining clips, remove the memory
module, and then reinsert it.
Figure 71. Memory module installation
Step 4. If needed, align a cable guide with the guide pins on the chassis; then, attach the cable guide to the
chassis wall, and slide it down to secure it in place.
.
Chapter 5 Hardware replacement procedures
105