8-Dw Gpu Model Cable Routing - Lenovo ThinkSystem SR675 V3 User Manual

Figure 173. Cable routing for the OCP module
Cable From
System board assembly: PCIe connectors 11 and
1
12

8-DW GPU Model cable routing

Follow the instructions in this section to learn how to do cable routing for the 8-DW GPU Model.
Notes:
1. Go through the following sections in
information before starting cable routing.
2. Make sure to remove the top of the cross bar before routing the cables.
3. Make sure to route the cables through cable guide and cable clip as instructed in the cable routing
guides. See the illustration below for the cable guide and cable clip locations.
ThinkSystem SR675 V3 User Guide
206
To
System board assembly: PCIe connector 9
"Identifying connectors" on page 195 to acquire necessary