Lenovo ThinkSystem SR675 V3 User Manual page 102

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack. See
• If one or more NVMe solid-state drives are to be removed, it is recommended to disable them beforehand
via the operating system.
• Before you remove or make changes to drives, drive controllers (including controllers that are integrated
on the system board assembly), drive backplanes or drive cables, back up all important data that is stored
on drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Make preparation for this task.
a. Remove the top cover. See
b. Remove the M.2 drives. See
Step 2. Disconnect the M.2 backplane cables from the system board assembly.
a. Press and hold the latches on the M.2 cables.
b. Disconnect the cables from the system board assembly.
Figure 59. M.2 backplane cable disconnection
ThinkSystem SR675 V3 User Guide
94
54.
"Remove the server from rack" on page
.
"Remove the top cover" on page
"Remove an M.2 drive" on page
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
154.
92.
54.