Lenovo ThinkSystem SR675 V3 User Manual page 126

Figure 85. PCIe riser 1 installation (with serial port module)
After you finish
1. Reconnect the required cables.
2. Reinstall the PCIe riser 2. See
3. Complete the parts replacement. See
Install PCIe riser 2 installed with serial port module
Procedure
Step 1. Install the PCIe riser 2 installed with the serial port module.
Attention: Make sure the serial port cable is routed through the cable clip inside the PCIe riser.
a. Connect the serial port cable to the serial port connector on the system board assembly.
b. Align the guide hole on the PCIe riser with the guide post on the system board assembly;
then, insert the PCIe riser into the PCIe slot on the system board assembly.
c. Fasten the thumbscrew to secure the PCIe riser.
ThinkSystem SR675 V3 User Guide
118
"Install a PCIe riser" on page
"Complete the parts replacement" on page
115.
194.