Lenovo ThinkSystem SR675 V3 User Manual page 140

• Go to "Update the firmware" on page 217
Watch the procedure
A video of this procedure is available at YouTube:
AgTVLhsU24Nhel3_oYlnGT
Procedure
Step 1. Remove the processor socket cover.
Step 2. Install the processor.
a. Slide the processor carrier into the rail frame.
b. Push the rail frame down until the blue latches lock into place; then, close the retention
frame.
c. Use a Torx T20 screwdriver to tighten the screw.
Figure 97. Processor installation
After you finish
1. Install the heat sink. See
2. Complete the parts replacement. See
Install a heat sink
Follow the instructions in this section to install a heat sink. This task requires a Torx T20 driver. The
procedure must be executed by a trained technician.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Record the processor identification label.
ThinkSystem SR675 V3 User Guide
132
for more information on firmware updating tools.
.
"Install a heat sink" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
54.
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
132.
194.
to ensure that you