Rear Drive Assembly Replacement; Remove The 2.5-Inch Rear Drive Assembly - Lenovo ThinkSystem SR635 V3 User Manual

Step 1. Touch the static-protective package that contains the RAID flash power module to any unpainted
surface on the outside of the server. Then, take the RAID flash power module out of the package
and place it on a static-protective surface.
Step 2. Install the RAID flash power module on the riser.
Figure 116. Installation of the RAID flash power module on the riser
a. Open the retention clip on the holder.
b. Put the RAID flash power module into the holder and press it down to secure it into the
holder.
c. Rotate the latch on the riser bracket to the open position.
d. Align the RAID flash power assembly with the slot on the riser card. Then, carefully press
the RAID flash power assembly straight into the slot until it is securely seated and its bracket is
secured.
After you finish
1. Install the riser assembly on the chassis. See
2. Connect the flash power module to an adapter with the extension cable that comes with the flash power
module. See "RAID flash power modules" on page
3. Complete the parts replacement. See

Rear drive assembly replacement

Use this information to remove and install the rear drive assembly.

Remove the 2.5-inch rear drive assembly

Use this information to remove the 2.5-inch rear drive assembly.
About this task
"Install a riser card" on page
227.
"Complete the parts replacement" on page
Chapter 5
181.
215.
.
Hardware replacement procedures
169