Hot-Swap Power Supply Unit Replacement; Remove A Hot-Swap Power Supply Unit - Lenovo ThinkSystem SR630 Maintenance Manual

Step 4. Install the EDSFF drive cage cover.
Figure 71. EDSFF drive cage cover installation
a. Install the drive cage cover in place.
b. Close the drive cage handle.
After you finish
1. Reinstall the security bezel if you have removed it. See "Install the security bezel" on page 204.
2. Use the Lenovo XClarity Provisioning Manager V3 to configure the RAID if necessary. For more
information, see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_v3_about.html

Hot-swap power supply unit replacement

Use this information to remove and install a hot-swap power supply unit.

Remove a hot-swap power supply unit

Use this information to remove a power supply unit.
About this task
Note: If the power supply unit to be removed is the only one installed, the power supply is non-hot-swap
and before removing it, you must turn off the server first. To support redundancy mode or hot-swap, install
an additional hot-swap power supply.
Safety information for AC power supplies
ThinkSystem SR630 V2 Maintenance Manual
130