Audio Output Line [N] Delay Mode; Audio Soundsandalerts Ringtone; Audio Soundsandalerts Ringvolume; Audio Ultrasound Maxvolume - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Audio Output Line [n] Delay Mode

n: 1..1
You may add extra delay to an audio line output with the Audio Output Line [n] Delay
DelayMs setting. The extra delay added is either a fixed number of milliseconds, or
a number of milliseconds relative to the detected delay on the HDMI output (typically
introduced by the connected TV).
Requires user role: ADMIN, INTEGRATOR
Default value: RelativeToHDMI
Value space: Fixed/RelativeToHDMI
Fixed: Any extra delay (DelayMs) added to the output, will be a fixed number of
millisecond.
RelativeToHDMI: Any extra delay (DelayMs) added to the output, will be relative to the
detected delay on the HDMI output. The actual delay is HDMI-delay + DelayMs. The
Audio Output Connectors Line [n] DelayMs status reports the actual delay.

Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: Sunrise
Value space: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.

Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, INTEGRATOR, USER
Default value: 50
Value space: Integer (0..100)
Range: The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 =
Off.
D15330.18 SX10 Administrator Guide CE9.12, APRIL 2020.
Configuration Peripherals Maintenance

Audio Ultrasound Mode

This setting applies to the Intelligent Proximity feature. Keep the setting at its default value.
Requires user role: ADMIN, INTEGRATOR
Default value: Dynamic
Value space: Dynamic/Static
Dynamic: The device adjusts the ultrasound volume dynamically. The volume may vary
up to the maximum level as defined in the Audio Ultrasound Volume MaxVolume setting.
Static: Use only if advised by Cisco.

Audio Ultrasound MaxVolume

This setting applies to the Intelligent Proximity feature. Set the maximum volume of the
ultrasound pairing messages.
The Audio Ultrasound MaxVolume and Proximity Mode settings only affect ultrasound
pairing messages. See the RoomAnalytics PeoplePresenceDetector and Standby
WakeupOnMotionDetection settings for information about the use of ultrasound in presence
and motion detection.
Requires user role: ADMIN, INTEGRATOR
Default value: 70
Value space: Integer (0..70)
Select a value in the specified range. If set to 0, ultrasound pairing messages are not
emitted.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
112
Administrator Guide
Device settings Device settings Appendices