Gpio Settings; Gpio Pin [1..4] Mode - Cisco TelePresence SX80 Administrator's Manual

Cisco TelePresence SX80

Introduction

GPIO settings

GPIO Pin [1..4] Mode

The four GPIO pins are configured individually. The state can be retrieved by xStatus GPIO
Pin [1..4] State. The default pin state is High (+12 V). When activated as an output, a pin is
set to 0 V (Low); when deactivated, it is set to +12 V (High). To activate a pin as an input, the
voltage on the pin must be pulled down to 0 V; to deactivate it, raise the voltage to +12 V.
Requires user role: ADMIN, INTEGRATOR
Default value: InputNoAction
Value space: InputAcceptAllCalls/InputDisconnectAllCalls/InputMuteMicrophones/
InputNoAction/OutputAllCallsEncrypted/OutputInCall/OutputManualState/
OutputMicrophonesMuted/OutputPresentationOn/OutputStandbyActive
InputAcceptAllCalls: When the pin is activated, the xCommand Call Accept command,
which accepts all incoming calls, will be issued.
InputDisconnectAllCalls: When the pin is activated, the xCommand Call Disconnect
command, which disconnects all calls, will be issued.
InputMuteMicrophones: When the pin is activated, the microphones will be muted. When
deactivated, the microphones will be unmuted.
InputNoAction: The pin state can be set, but no operation is performed.
OutputAllCallsEncrypted: The pin is activated when all calls are encrypted, and
deactivated when one or more calls are not encrypted.
OutputInCall: The pin is activated when in call, and deactivated when not in call.
OutputManualState: The pin state can be set by xCommand GPIO ManualState Set PinX:
<High/Low>. It is set to +12 V or 0 V, respectively.
OutputMicrophonesMuted: The pin is activated when microphones are muted, and
deacti¬vated when not muted.
OutputPresentationOn: The pin is activated when presentation is active, and deactivated
when presentation is not active.
OutputStandbyActive: The pin is activated when the system is in standby mode, and
deacti¬vated when no longer in standby.
D15328.07 SX80 Administrator Guide CE9.1, JUNE 2017.
Configuration Peripherals Maintenance
www.cisco.com — Copyright © 2017 Cisco Systems, Inc. All rights reserved.
102
Administrator Guide
System settings System settings Appendices