Table of Contents
Advertisement
4
Rear Fenders and Tailskirt
4.
Disconnect the three taillight wires.
5.
Using a 10 mm socket, remove the three fasteners (5) that attach the rear fender (4) to vehicle frame (Figure
4-8, Page 4-17).
6.
Using a 10 mm socket, remove the two M6 screws (2) that attach the tailskirt (3) to the vehicle frame.
7.
Remove fenders and tailskirt.
REAR FENDER AND TAILSKIRT INSTALLATION
1.
Using a 10 mm socket, install the two screws (2) that attach the tailskirt (3) to the vehicle frame (Figure 4-8,
Page 4-17). Tighten to 44 in·lb (5 N·m).
2.
Using a 10 mm socket, install the three fasteners (5) that attach the rear fender (4) to the vehicle frame. Tighten
to 5 in·lb (0.56 N·m). Do not over torque.
3.
Connect the taillight wires.
4.
Install the two bolts and nuts that secure taillight to the rear fender.
5.
Connect the three taillight wires.
6.
Install the tilt bed. See Tilt Bed Installation on page 4-13.
7.
Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-4. See Connecting the
Battery – Gasoline Vehicles, Section 1, Page 1-4.
Page 4-18
2015 Carryall 550 Maintenance and Service Manual
BODY AND TRIM
Advertisement
Table of Contents
Troubleshooting
