Table of Contents
Advertisement
18
Test Procedures
4.1. Probe the two, small metal contacts on the top of the fuse (Figure 18-8, Page 18-19).
4.2. Each contact should show battery voltage.
4.3. If only one side shows battery voltage, replace fuse.
4.4. If neither side of a fuse shows battery voltage, inspect the following locations:
– 12-pin dash wire harness connector, key switch and sonic weld 3.
5.
2-amp ABC Glass Fuse Only: With the key switch in the ON position:
5.1. Probe the wire on each side of the fuse with insulation-piercing probes.
5.2. Each probe should show battery voltage.
5.3. If only one side shows battery voltage, replace fuse.
5.4. If neither side of a fuse shows battery voltage, inspect the following locations:
– 5-amp ATM fuse, 12-pin dash wire harness connector, key switch and sonic weld 3.
Page 18-20
2015 Carryall 550 Maintenance and Service Manual
TROUBLESHOOTING AND ELECTRICAL SYSTEM:
PEDAL-START GAS VEHICLE
Advertisement
Table of Contents
Troubleshooting
