Table of Contents
Advertisement
6
Rear Brake Cables
REAR BRAKE CABLES
REAR BRAKE CABLE REMOVAL
1.
Chock wheels to keep vehicle from unintentionally moving.
2.
Release park brake if latched and loosen equalizer retaining nuts (13 and 14) on equalizer rod (2) to slightly
loosen brake cables (7) (Figure 6-24, Page 6-17).
3.
Rotate brake cables (7) upward and pull ends through holes in top of equalizer (3).
4.
Disconnect brake cables (7) at rear wheels.
4.1. Remove bow-tie pins (8), clevis pins (5), and E-clips (6) (Figure 6-24, Page 6-17).
4.2. Remove cable (7) from plate under leaf spring.
4.3. Note location of hangers (for installation of cables) and pull cables out of vehicle.
REAR BRAKE CABLE INSTALLATION
1.
Place the cable ends in the equalizer (3) (Figure 6-24, Page 6-17). Route cables through hangers in the same
manner as the ones removed.
2.
At the rear wheel brakes, connect the cables (7) to the brake actuator arms using clevis pins (5) and new
bow-tie pins (8).
3.
Place cables (7) in plate under leaf springs and secure with E-clips (6).
4.
Adjust brakes as described in this section for the appropriate vehicle.
Page 6-16
2015 Carryall 550 Maintenance and Service Manual
WHEEL BRAKE ASSEMBLIES
Advertisement
Table of Contents
Troubleshooting
