Table of Contents
Advertisement
TRANSAXLE (ED65): GASOLINE VEHICLES
5.
Loosen jam nuts (1) securing shifter cable (2) to FNR/accelerator cable bracket (3) (Figure 26-14, Page 26-13).
Then, remove bowtie clip (3) to disconnect shifter cable end (4) from transaxle shift lever (5).
6.
Cut wire ties securing shifter cable to chassis.
7.
Make note of cable routing, then remove shifter cable from vehicle.
3064
Figure 26-13 Shifter Cable at FNR Handle
SHIFTER CABLE INSTALLATION
1.
Install shifter cable (2), routing it exactly as it was originally, from instrument panel to transaxle.
2.
Place rear of cable (2) in FNR/accelerator cable bracket with a jam nut (1) on each side of bracket (Figure 26-14,
Page 26-13). Tighten jam nuts (1) to 22 ft·lb (29.8 N·m).
3.
Hook shifter cable end (4) into transaxle shift lever (5) and secure with bowtie clip (3).
4.
Feed front of cable (2) through its mounting hole and push the plastic anchor into hole until tangs (4) snap
into place (Figure 26-13, Page 26-13).
5.
Snap cable end socket (1) onto stud (3) of Forward/Reverse shifter handle.
6.
Secure shifter cable along chassis with wire ties.
7.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-4.
SHIFTER CABLE ADJUSTMENT
Cable is properly adjusted when both the Forward/Reverse handle at instrument panel and shift lever on transaxle are
in the NEUTRAL position at the same time.
To adjust, the jam nuts (6) at the FNR/accelerator cable bracket must be loosened and moved forward or backward as
required (Figure 26-14, Page 26-13). Tighten jam nuts (6) to 22 ft·lb (29.8 N·m).
1
4
3065
2015 Carryall 550 Maintenance and Service Manual
Figure 26-14 Shifter Cable at Transaxle
26
Shifter Cable
1
Page 26-13
Advertisement
Table of Contents
Troubleshooting
