Torque Specifications; Adjustments And Settings; Engine Oil - Gasoline Vehicle - Club Car Carryall 550 2015 Maintenance And Service Manual

22
General Information

TORQUE SPECIFICATIONS

ITEM
Flywheel retaining nut
Crankcase cover to block bolts
Cylinder head bolts
Connecting rod bolts
Spark plug
Exhaust flange nuts
Ignition coil
Oil sensor
Oil drain plug
Fan housing screws
Fan cover screws
Bolts marked with "4" (when used with nuts)

ADJUSTMENTS AND SETTINGS

ITEM
Spark plug gap
Valve clearance – Intake & Exhaust (cold)
Ignition coil air gap
Compression pressure:
ENGINE OIL – GASOLINE VEHICLE
Even though the low oil warning light on the dash should illuminate if oil level becomes low, engine oil level should be
checked monthly. Vehicle should be on a level surface when checking oil. Do not overfill with oil.
Engine Oil Level Check
1. Remove the oil level dipstick from the oil filler tube, and wipe oil off dipstick (Figure 22-1). See following
CAUTION.
Page 22-2 2015 Carryall 550 Maintenance and Service Manual
SIZE
M18
M8
M10
M8
M8
13/16 in. (21 mm) plug socket
M8
M6
M6
M14
M6
M6
M8
M6
M5
0.0047 to 0.0059 in. (0.12 to 0.15 mm)
Allowable Lower Pressure: 120 psig (827 kPa)
ENGINE (SUBARU EX40)
TORQUE
80 ft·lb (110 N·m)
250 in·lb (28.3 N·m)
1 st Step
New head and bolts:
159 in·lb (18 N·m)
Used head and bolts:
159 in·lb (18 N·m)
159 in·lb (18 N·m)
221 in·lb (25 N·m)
New: 120 in·lb (13.5 N·m)
Re-tightening: 216 in·lb (24.5 N·m)
177 in·lb (20 N·m)
71 in·lb (8 N·m)
80 in·lb (9 N·m)
18 ft·lb (24.4 N·m)
90 in·lb (10 N·m)
25 in·lb (2.8 N·m)
130 in·lb (15 N·m)
50 in·lb (5.9 N·m)
30 in·lb (3.4 N·m)
VALUES
0.024 to 0.028 in. (0.6 to 0.7 mm)
0.012 to 0.020 in. (0.3 to 0.5 mm)
167 psig (1151 kPa)
2 nd Step
New head and bolts:
336 in·lb (38 N·m)
Used head and bolts:
265 in·lb (30 N·m)
2 nd step not needed