Rear Fender And Tailskirt Installation; Floor Mat; Floor Mat Removal; Floor Mat Installation - Club Car Carryall 300 2018 Maintenance And Service Manual

Gasoline vehicle with subaru ex40 engine electric vehicle with eric charging system
Table of Contents

Advertisement

4

Floor Mat

2.
Disconnect the battery cables and either discharge the controller or disconnect the spark plug wire(s). See
Disconnecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3.
Remove the tilt bed. See Tilt Bed Removal on page 4-14.
4.
Disconnect the three taillight wires.
5.
Using a 10 mm socket, remove the three fasteners (5) that attach the rear fender (4) to vehicle frame (Figure
4-8, Page 4-17).
6.
Using a 10 mm socket, remove the two M6 screws (2) that attach the tailskirt (3) to the vehicle frame.
7.
Remove fenders and tailskirt.

REAR FENDER AND TAILSKIRT INSTALLATION

1.
Using a 10 mm socket, install the two screws (2) that attach the tailskirt (3) to the vehicle frame (Figure 4-8,
Page 4-17). Tighten to 44 in·lb (5 N·m).
2.
Using a 10 mm socket, install the three fasteners (5) that attach the rear fender (4) to the vehicle frame. Tighten
to 5 in·lb (0.56 N·m). Do not over torque.
3.
Connect the taillight wires.
4.
Install the two bolts and nuts that secure taillight to the rear fender.
5.
Connect the three taillight wires.
6.
Install the tilt bed. See Tilt Bed Installation on page 4-14.
7.
Connect the batteries. See Connecting the Batteries – Electric Vehicles on page 1-4.
See Connecting the Battery- Gasoline Vehicles on page 1-3.
FLOOR MAT
See General Warnings on page 1-1.

FLOOR MAT REMOVAL

1.
Remove the brake and accelerator pedals. See Accelerator and Brake Pedal Group, Section 5, Page 5-1.
2.
Remove the top edge of the floor mat from the overlapping flange under the dash.
3.
Lift the mat from the vehicle.

FLOOR MAT INSTALLATION

1.
Install mat into vehicle. Ensure mat is laying flat.
2.
Install top edge of the floor mat into the overlapping flange under the dash.
3.
Install the brake and accelerator pedals. See Accelerator and Brake Pedal Group, Section 5, Page 5-1.
Page 4-18
2018 Carryall 300 Maintenance and Service Manual
BODY AND TRIM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents