Table of Contents
Advertisement
13
Solenoid
INSTALLING THE SPEED CONTROLLER COVER
1.
Place the curved edges on the bottom of the speed controller cover into the slots on the component mounting
plate.
2.
Press the speed controller cover onto the component mounting plate over the speed controller and other
electrical components.
3.
Install the three push rivets (5) (Figure 13-5, Page 13-10).
SOLENOID
See General Warnings on page 1-1.
The solenoid is located on the passenger side of the electrical component mounting plate.
TESTING THE SOLENOID
See Test Procedure 9 – Solenoid Activating Coil on page 12-24 and Test Procedure 10 – Solenoid Contacts on
page 12-25.
SOLENOID REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the speed controller cover. See Removing the Speed Controller Cover on page 13-7.
3.
Disconnect all wires from the solenoid (Figure 13-4, Page 13-8).
4.
Loosen, but do not remove, the two screws (1) that hold the solenoid (2) to the component mounting plate.
5.
Lift the solenoid (2) up and off of the component mounting plate.
1
Figure 13-4 Solenoid
SOLENOID INSTALLATION
1.
Mount solenoid (2) onto component mounting plate with screws (1) (Figure 13-4, Page 13-8).
2.
Tighten screws (1) to 60 in·lb (6.8 N·m).
Page 13-8
2015 Carryall 550 Maintenance and Service Manual
ELECTRICAL COMPONENTS: IQ PLUS
ELECTRIC VEHICLES
Advertisement
Table of Contents
Troubleshooting
