Table of Contents
Advertisement
TRANSAXLE (ED65): GASOLINE VEHICLES
TRANSAXLE REMOVAL
See General Warnings on page 1-1.
1.
Turn the key switch to the OFF position and remove the key, and place the Forward/Reverse handle in the
NEUTRAL position.
2.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-4.
3.
Place chocks at the front wheels and loosen lug nuts on both rear wheels.
4.
Disconnect air intake hose, vent hose, and fuel line from throttle body and accelerator cable from electrical
component box. See Fuel System: Gasoline Vehicles, Section 23, Page 23-1.
5.
Disconnect gray 18-pin connector from ECU.
6.
Disconnect braided ground cable from engine (Figure 18-9, Page 18-21).
7.
Pedal-Start Vehicles Only: Disconnect 3-wire plug from limit switch on transaxle.
8.
Disconnect three wires of main wire harness from starter/generator (Figure 20-13, Page 20-10).
9.
Loosen jam nuts (1) securing shifter cable (2) to FNR/accelerator cable mounting bracket. Then, remove bowtie
clip (3) to disconnect shifter cable end (4) from transaxle shift lever (5) and set shifter cable (2) aside (Figure
26-14, Page 26-13).
10. Remove bolts (1) securing governor cable bracket (2) and FNR/accelerator cable bracket (3) to transaxle (Figure
26-6, Page 26-9). Do not disconnect cables (4 and 5).
11. Unhook governor cable (4) and accelerator cable (5) from the governor arm (7).
1
3059
Figure 26-6 Governor Arm, Cable and Brackets
12. Disconnect brake cables from brake assemblies. See Wheel Brake Assemblies section.
13. Remove lower shock mounting hardware from both rear shocks (Figure 26-7, Page 26-9).
1
3060
Figure 26-7 Disconnect Shock Absorbers
2015 Carryall 550 Maintenance and Service Manual
26
Transaxle Removal
Page 26-9
Advertisement
Table of Contents
Troubleshooting
