Table of Contents
Advertisement
FUEL SYSTEM: GASOLINE VEHICLES
WARNING
• Always install ground wires during reassembly.
4.
Connect fuel line (3) to fuel pump module (1). See Fuel Line Installation on page 23-17. See following
DANGER.
DANGER
• Ensure line is connected properly to avoid a leak that can cause a fire.
5.
Connect wire harness plug (2) to fuel pump module (1).
6.
Clean spilled and remove any drained gasoline from the area.
7.
Connect battery. See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-4.
8.
Add fuel to tank.
9.
Place the Forward/Reverse handle in the NEUTRAL position, chock the wheels, and the neutral lockout switch in
the MAINTENANCE position (Figure 26-1, Page 26-1).
10. Turn key switch to the ON position and check for fuel leaks. Repeat as necessary to build fuel pressure. Any
leaks found must be fixed.
DANGER
• Repair all fuel leaks before returning the vehicle to service.
11. If no leaks are found, place the neutral lockout switch in the OPERATE position (Figure 26-1, Page 26-1).
FUEL FILTER
See General Warnings on page 1-1.
GENERAL INFORMATION
The fuel filter is located in the fuel tank. It is part of the fuel pump module assembly and should last the life of the
vehicle; however, it is replaceable if the need should arise. In addition, the module assembly features a fuel pickup
screen to catch larger particles before entering the fuel filter.
FUEL FILTER REMOVAL
1.
Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2.
Disconnect battery. See Disconnecting the Battery – Gasoline Vehicles, Section 1, Page 1-4.
3.
Remove fuel pump module (1). See Fuel Pump Module Removal on page 23-18.
4.
Disconnect flex hoses (12 and 13) from filter (14) (Figure 23-15, Page 23-20).
4.1. Pull hose retainer clip straight up and out of filter (14). Do not discard clip.
2015 Carryall 550 Maintenance and Service Manual
23
Fuel Filter
Page 23-23
Advertisement
Table of Contents
Troubleshooting
