Battery Warning Light Installation; Forward/Reverse Rocker Switch; Testing The Forward/Reverse Rocker Switch; Forward/Reverse Rocker Switch Removal - Club Car 2009 Electric Precedent Maintenance And Service Manual

ELECTRICAL COMPONENTS

BATTERY WARNING LIGHT INSTALLATION

1. Install in reverse order of removal.
2. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI P/N
1014305) to minimize corrosion.
704
Figure 15-3 Battery Warning Light

FORWARD/REVERSE ROCKER SWITCH

See General Warnings on page 1-1.

TESTING THE FORWARD/REVERSE ROCKER SWITCH

See Test Procedure 23 – Forward/Reverse Rocker Switch on page 11-32 or 12-32.

FORWARD/REVERSE ROCKER SWITCH REMOVAL

1. Disconnect the battery cables and discharge the controller as instructed. See WARNINGS "To avoid
unintentionally starting..." and "After disconnecting the batteries, wait 90 seconds..." in General
Warnings on page 1-1.
2. Remove two screws (2) that hold Forward/Reverse rocker switch housing (1) to the vehicle (Figure 15-4, Page
15-4).
3. Remove the three wires from the rocker switch.
4. Press in on the locking tabs on each side of switch (3), and push switch out of housing.
11
2009 Electric Precedent Maintenance and Service Manual
Forward/Reverse Rocker Switch
15
Page 15-3