Ul Ordinary Locations Per Report Reference E175199-20230421; Ul Hazardous Locations Per Report Reference E198726-19980911 - WAGO 750 Series Manual

Hide thumbs Also See for 750 Series:
Table of Contents

Advertisement

Serie 750, 753
Manual statements issued on 2021-07-16
For Bus coupler, Bus controller for 24V system supply input voltage an external fuse,
rated max. 2A, slow acting, min. 30Vdc shall be used.
For field supplied Module (also supplied by Power jumper contacts) for 24V field supply
input voltage an external fuse, rated max. 10A, slow acting, min. 30Vdc shall be used.

10.1.2.5 UL Ordinary Locations per Report Reference E175199-20230421

Because the following information refers to language-specific regulations, standards or
certifications applicable to the specific installation and operation location, it is presented
in the respective original language.
Manual statements issued on 2023-04-21
For Bus coupler, Bus controller for 24V system supply input voltage an external fuse,
rated max. 2A, slow acting, min. 30Vdc shall be used.
For field supplied Module (also supplied by Power jumper contacts) for 24V field supply
input voltage an external fuse, rated max. 10A, slow acting, min. 30Vdc shall be used.

10.1.2.6 UL Hazardous Locations per Report Reference E198726-19980911

Note
Valid Installation Regulations
The underlying installation regulations are covered by the instruction leaflet and the prod-
uct manuals at the time of manufacture prior to August 19, 2022.
Because the following information refers to language-specific regulations, standards or
certifications applicable to the specific installation and operation location, it is presented
in the respective original language.
Installation and operating instructions revised on 2022-12-08
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and D Or nonhaz-
ardous locations only.
This equipment is to be fitted within tool-secured enclosures only.
English
WARNING - EXPLOSION HAZARD - SUBSTITUTION
OF COMPONENTS MAY IMPAIR SUITABILITY FOR
CLASS I, DIV. 2.
Applicable for each operator accessible connector and fuse holder:
English
WARNING - DO NOT DISCONNECT EQUIPMENT
UNLESS POWER HAS BEEN SWITCHED OFF OR
THE AREA IS KNOWN TO BE NON-HAZARDOUS
System manual | Version: 3.3.1
French
ATTENTION – DANGER D'EXPLOSION –
L'ÉCHANGE DE COMPOSANTS PEUT ALTÉRER
L'APTITUDE DE CLASSE I, DIV. 2.
French
ATTENTION – NE DÉBRANCHER L'APPAREIL
QU'EN L'ABSENCE DE COURANT OU LORSQUE LA
ZONE EST CONSIDÉRÉE SANS RISQUE D'EXPLO-
SION.
Appendix
59

Advertisement

Table of Contents
loading

This manual is also suitable for:

753 series

Table of Contents