WAGO 750 Series Manual page 50

Assembly and Disassembly
2. Pull the I/O module out of the assembly by the release tab.
ð When the I/O module is pulled out of the assembly, the electrical connections of the
data and power contacts are disconnected.
Removing 753 Series I/O Modules
1. Remove the pluggable connector by pulling the orange locking latch towards the top
edge of the I/O module.
ð The release tab is then accessible.
2. Pull up the orange release tab on the I/O module.
50 System manual | Version: 3.3.1
Serie 750, 753
Figure 28: Pulling the Release Tab
Figure 29: Pulling the Locking Latch