Table of Contents
Advertisement
[scdttime-080413-01.tif, 1, en_US]
Figure 8-48
The Date & Time menu items show you the current values, which are continually updated. You can also
change entries here.
Time Synchronization Indications
Internal time synchronization is monitored cyclically. Important synchronization processes, the status of time
sources and errors detected are reported and entered in the operational log. For this purpose, see the list of
indications for internal date and time synchronization in the System Functions Device manual.
NOTE
i
i
In case of a missing or discharged battery, the device starts without active external time synchronization
with the device time 2011-01-01 00:00:00 (UTC).
Setting the Contrast of the Device Display
8.8.5
You can enter the contrast setting only on the device via the navigation keys on the on-site operation panel.
Procedure
•
Open the contrast menu by pressing the Left + Right navigation keys simultaneously.
•
If prompted, change the contrast intensity +/- using the Right/Left navigation keys.
•
You can restore the basic setting by simultaneously pressing the Up + Down navigation keys.
•
Then confirm the setting changes with Enter.
[sckontra-080413-01.tif, 1, en_US]
Figure 8-49
Changing the Language on the Device
8.8.6
If the Language of the operation panel was configured in DIGSI 5, you can select between the national
language and US English on the device at any time.
•
To reach the setting dialog for the language selection, press the function key <F9>.
•
Use the up/down navigation keys to select the languages.
•
Finally, confirm the setting changes with Ok.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
Date and Time Setting
Contrast Setting of the Device Display
Operation in the Operating State
8.8 Change Device Settings
171
Advertisement
Table of Contents
