5.3
Displays for Indication and Control
Displays
Displays for indication and control offer you the possibility of quickly obtaining an overview of important oper-
ating modes. You can configure a total of up to 10 displays in DIGSI 5 using the display editor. The following
contents are available here:
•
Dynamically updated measured values
•
Status of indications
•
Switch positions of switching objects
•
Texts
•
Graphical elements
NOTE
i
i
The displays and controls are displays created in DIGSI 5.
Default Displays
In the idle state, that is, provided there is no fault, the display with DIGSI 5 can show configurable operating
information (for example, operational measured values). If preconfigured in DIGSI 5, display images can be
suppressed by spontaneous displays in the event of a fault.
A device ready for operation will show you the following display image after booting. This presupposes you
have not parameterized a display image with DIGSI 5. The standard display image (default display) is parame-
terized and defined in DIGSI 5. If a parameterized and defined display image exists, it is displayed after
booting.
[scligrdi-080413-01.tif, 1, en_US]
Figure 5-4
You reach the standard display diagram at any time (exception: in case of fault) by holding down the left navi-
gation key.
If several display images are available, you can select them in order of parameterized sequence by pressing the
right and the left navigation keys.
Control Displays
In devices with large graphic display, entire control displays can also be graphically depicted. The control
displays can graphically and dynamically update the switch position of switching objects. In addition, control
displays offer you the possibility of selecting individual switching objects and activating them according to
switching authority and switching mode.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
Standard Display Diagram
Using On-Site Operation Panel
5.3 Displays for Indication and Control
77