Communication-Supervision Log - Siemens SIPROTEC 5 V7.80 Operation

[sccommlg-090413-01.tif, 1, en_US]
Figure 8-30
Deletability
The communication logs of your SIPROTEC 5 device can be deleted. Read details about this in chapter
8.5.12 Saving and Deleting the
Configurability
The communication logs are not freely configurable. The entries are preconfigured.

Communication-Supervision Log

8.5.10
The communication-supervision log is used to log communication events.
Currently, the following events are logged:
•
Status for each GOOSE subscription (if configured)
It is logged whether the GOOSE subscription received valid messages or not.
•
Aggregated status for all GOOSE subscriptions
The status is TRUE, if at least one GOOSE subscription does not receive a valid message.
•
Subscriber in simulation mode
GOOSE messages are processed with a simulation flag. The status is TRUE when at least one GOOSE
subscription processes simulated messages.
Reading from the PC with DIGSI 5
•
To reach the communication-supervision log of your SIPROTEC 5 device, use the project-tree window.
Project → Device → Process data → Logs → Com Supervision log
The status of the communication-supervision log last loaded from the device is shown to you.
•
To update (synchronization with the device), click the button Read log entries in the headline of the
indication list.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
Reading the Communication Log on the On-Site Operation Panel of the Device
Logs.
Operation in the Operating State
8.5 Logs
149