Reading Indications From The Pc With Digsi 5 - Siemens SIPROTEC 5 V7.80 Operation

Reading Indications from the PC with DIGSI 5

8.4.3
Procedure
Menu Path (Project)
Project → Device → Process data → Log →
Online access → Device → Device information → Log
tab →
Online access → Device → Test suite → Communica-
tion module →
To read the indications with DIGSI 5 your PC must be connected via the USB user interface of the on-site
operation panel or via an Ethernet interface of the device. You can establish a direct connection to your PC
via the Ethernet interfaces. It is also possible to access all connected SIPROTEC 5 devices via a data network
from your DIGSI 5 PC.
You access the desired logs of the SIPROTEC 5 device, use the project-tree window. If you have not
²
created the device within a project, you can also do this via the Online access menu item.
After selecting the desired log, you are shown the last state of the log loaded from the device. To update, it is
necessary to synchronize with the log in the device.
Synchronize the log. For this purpose, click the appropriate button in the headline of the log (see the
²
ground-fault indications example in
[scgrflmd-191012-01, 1, en_US]
Figure 8-7
You will find additional information about deleting and saving logs in chapter
Logs.
Which indications can be shown in the selected log depends on the assignments in the DIGSI 5 information
routing matrix or is predefined. You will find information about this in chapter
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
Figure 8-7
DIGSI 5 Display of an Indication List (Example of Ground-Fault Log)
Log
Operational log
Setting changes
Fault log
User indications 1
User indications 2
Motor-starting log
Ground-fault log
Device-diagnosis log
Security indications
Communication indications
a)).
8.5.12 Saving and Deleting the
8.5.1
Operation in the Operating State
8.4 Indications
General.
127