Fold Mirror - Christie CP4230 Service Manual

Section 5: Parts and Module Replacement

5.8.2 Fold Mirror

The fold mirror is located under the front section of the projector.
(Estimated Replacement Time: 30 minutes + 15 minute calibration)
1. Remove the four, 3mm screws securing the fold mirror cover plate under the front portion of the projector.
Remove cover plate. (Figure 5-23)
2. Remove one, 2.5mm screw from each of the three tabs. (Figure 5-24)
3. Loosen the other 2.5mm screw from each of the three tabs.
4. Holding the mirror in place, swing the tabs out to the side.
5. Carefully lower the mirror and remove.
6. When installing, repeat instructions in reverse. Adjust the fold mirror as needed. For details, refer to
Fold Mirror Alignment, on page
5-18
Figure 5-23 Remove Cover Plate
Figure 5-24 Fold Mirror Tabs
3-2.
3.1
CP4230 Service Manual
020-100622-04 Rev. 1 (05-2016)