Panel mode
Use this read-only menu to view the operating mode of the control panel.
To view the operating mode:
1. Set the display as shown below, and then press Enter.
Display indications for each operating mode are shown below.
Display
Operating mode
EN 54-2
EN 54-2 Evacuation
EN 54-2 Scandinavia
BS 5839-1 (No second stage)
BS 5839-1 (second stage)
NBN S 21-100
NEN 2535
Custom
See Appendix A "Configuration presets" on page 89 for presets and default
settings for each operating mode.
Custom operating mode
A custom operating mode will be indicated if any of the following zone
configuration settings are changed from the operating mode preset values:
•
Zone delay
•
Zone configuration
•
Zone type
•
Input configuration
The seven-segment display will alternate the custom and base operating mode
indications, as shown above.
ZP1-F Series Installation Manual
Chapter 3: Configuration and commissioning
37