Ziton ZP1-F2 Installation Manual page 105

Table 66: Expansion board event configuration with EN 54-13 supervision enabled
Display Event
24 Alarm
25 Fault
26 Alarm
Fault
29 Fault [1]
30 Alarm
Fault [1]
[1] Fail-safe mode: output is active when there is no fault.
[2] These presets are only available for 2010-1-SB supervised expansion boards.
[3] NEN 2535 only. Fault warning output open supervision (subject to input configuration).
[4] RB/SBx is the expansion board x. For two-zone and four-zone panels, x can be 1 or 2. For 8
zone and evacuation panels, x can be 1, 2, 3 or 4.
Configuration 36 is only possible when the Network Remote Output Control option (nO) is set
and it is then configured by default
[5] Not compliant to EN54-13.
Table 67: Expansion board sounder circuit configuration with EN 54-13 supervision
enabled [1]
Display
90 [2]
91
92 [2]
[1] These presets are only available for supervised expansion boards.
[2] NBN S 21-100 only
ZP1-F Series Installation Manual
Outputs Delay
1 and 2, No
3 and 4
1 and 2 No
3 and 4
1 and 2 No
3 and 4
1 and 2 No
3 and 4
1 and 2 No
3 and 4
Events
Evacuation sounders
Warning sounders
Sounders (or
Evacuation sounders
for NBN S 21-100)
Warning sounders
Appendix A: Configuration presets
Display Event
32 [2] Fire protection 1 and 2
Fault warning
output [3]
Fault [1], [5]
33 Buzzer on
Reset on
34 [2] Fire routing
(auto)
Fire routing
(manual)
35 [2] Fire routing
Fault warning
output [3]
Fault [5]
36 [4] Remote
RB/SBx.01-02
output
activation
Remote
RB/SBx.03-04
output
activation
Output
1 and 2
3 and 4
1 and 2 or 3 and 4
1 and 2 or 3 and 4
Outputs Delay
No
3
4
1 and 2 No
3 and 4
1 and 2 No
3 and 4
1 and 2 No
3
4
1 and 2 No
3 and 4 No
Delay
No
No
No
No
99