Ziton ZP1-F2 Installation Manual page 38

Chapter 3: Configuration and commissioning
To exit configuration mode without saving your changes:
1. Press Reset
— or —
1. Set the display as shown below, and then press Enter.
The control panel will exit configuration mode after 5 minutes if no button is
pressed.
Visual indications for current value and selected value
Current and selected values are indicated as follows.
Table 18: Visible indications for values
Status Indication
Current value Both decimal points on the display
are steady
New selected value Both decimal points on the display
are flashing
Other value Both decimal points on the display
are off
To restore the previous configuration:
1. Set the display as shown below, and then press Enter.
To restore the factory configuration:
1. Set the display as shown below, and then press Enter.
32 ZP1-F Series Installation Manual