Configuration Overview; Configuration Controls - Ziton ZP1-F2 Installation Manual

Configuration overview

To facilitate rapid configuration of the most common tasks, configuration is
divided into basic and advanced levels.
For basic configuration options, see "Basic configuration" on page 33. For
advanced configuration options see "Advanced configuration" on page 43.
Note: The reset and panel silence functions are not available in configuration
mode. To reset the control panel or silence the internal buzzer, first exit
configuration mode. See "Common configuration tasks" on page 31 for
instructions on exiting from configuration mode.

Configuration controls

The control panel is configured using the front panel configuration controls and
the seven-segment display. The configuration controls are also used to enter the
user level password.
The configuration controls
The configuration controls are located on the control panel interface.
Figure 18: Front panel configuration controls
Button Function
1 Scrolls to the next configuration menu on the seven-segment display.
2 Scrolls to the next configuration value for the active menu on the seven-segment
display.
3 Scrolls to the previous configuration menu on the seven-segment display.
4 Scrolls to the previous configuration value for the active menu on the seven-segment
display.
Enter Confirms a menu selection or a value selection entry. [1]
[1] Panels configured as repeaters in a fire network normally display the status of several panels.
Pressing this button for 3 seconds provides a temporary display of local panel status.
ZP1-F Series Installation Manual
Chapter 3: Configuration and commissioning
29