Connecting The Emulation Probe To A Site Lan - Agilent Technologies E5900B User Manual

Connecting the Emulation Probe to a LAN

Connecting the Emulation Probe to a Site LAN

Connecting the Emulation Probe to a Site LAN
1 Connect the LAN cable to the connector on the emulation probe.
Be sure to use the appropriate Category 3 or Category 5 cable for your LAN.
Do not use the LAN cable supplied with the emulation probe—it is a crossover
cable used for point-to-point connections only.
2 Find out the IP address and other LAN parameters to use for the
emulation probe. See "To obtain an IP address" on page 29.
3 Decide how you want to configure the LAN parameters:
If you have this equipment..
Emulation probe only
Emulation probe and a logic
analysis system without an
E5901B emulation module
Emulation probe and a logic
analysis system with an E5901B
emulation module
4 Verify that your emulation probe is now active and on the network. See
"To verify LAN communications" on page 38.
28
Use this procedure
"To configure LAN parameters using a serial
connection" on page 30, or
"To configure LAN parameters using DHCP"
on page 33
"To configure LAN parameters using a logic
analysis system without an emulation module"
on page 34
"To configure LAN parameters using a logic
analysis system with an emulation module" on
page 35
E5900B / E5901B User's Guide Supplement