Agilent Technologies E5900B User Manual page 64

See Also
temporarily to read registers and memory. These states that the debugger
introduces will also show up in your trace listing.
If you define a trigger on some state and the debugger happens to read the
same state, then you may falsely trigger your analyzer measurement. In
summary, when you are making an analysis measurement be aware that the
debugger could be impacting your measurement.
Important reminders
• Running a logic analyzer measurement does not run the processor. Usually
you will need to start the logic analyzer measurement by selecting 5XQ in
the logic analyzer, then start the processor running by selecting 5XQ in the
Emulation Control Interface or your debugger.
• If the processor stops running during a logic analyzer measurement, you
may need to manually stop the logic analyzer measurement before you see
a listing.
The "Coordinating Logic Analysis with Processor Execution" chapter in your
processor-specific Solution User's Guide.
"Emulation probe electrical characteristics" on page 80 for the electrical
characteristics of the TRIG OUT and BREAK IN signals.
E5900B / E5901B User's Guide Supplement
Coordinating Logic Analysis with Processor Execution
63