Agilent Technologies E5900B User Manual page 40

2 To view the LAN parameters, enter the lan command at the terminal
3 To exit from this telnet session, type <CTRL>D at the prompt.
If You Have Problems "Problems with the LAN Interface" on page 97.
interface.
interface prompt.
The best way to change the emulation probe's IP address, once it has already
been set, is to telnet to the emulation probe and use the terminal interface lan
command to make the change. Remember, after making your changes, you
must cycle power before the changes take effect. Doing this will break the
connection and end the telnet session.
To use telnet on a 16700-series logic analysis system, select the System Admin
icon, select the 1HWZRUNLQJ tab, then select WHOQHW .
Example
$ telnet 192.35.12.6
R>lan
lan is enabled
lan -i 192.35.12.6
lan -g 0.0.0.0
lan -s 255.255.248.0
lan -p 6470
Ethernet Address : 08000F090B30
E5900B / E5901B User's Guide Supplement
Connecting the Emulation Probe to a LAN
Verifying LAN Communications
39