Configure And Enable The Ftp Function - Beckman Coulter MET ONE 3400 Instructions For Use Manual

Operation
Export Data
Table 7.1 Sample Status Bit Mask Definitions
Bit Value
11 2048
12 4096
13 8192
14 16384
15 32768

Configure and Enable the FTP Function

With firmware V4.09, the particle counter can be configured to transmit data via Ethernet (wired
or wireless when the wireless option is installed) to an FTP server. This particle counter can connect
to servers that use FTP or FTPS (Explicit TLS/SSL).
1
For the user account that will be used in the particle counter, give file access on the FTP server:
Read, Write and Delete.
2
For the user account that will be used in the particle counter, give directory access on the FTP
server: Create, Delete, List and Add Subdirectories.
NOTE
The Create, Delete and Add Subdirectories rights are only necessary if the particle counter will be
configured to make subdirectories. These rights are not necessary when the particle counter is
configured to use the existing directories.
3
On the Counter Navigation screen, push
4
Select
Configure FTP
5
Select
Network Server Enabled
6
In the Host/IP Addr field, enter the host name or the IP address of the computer where the FTP
server is installed.
7
In the Port field, enter the port number on which the FTP server listens.
8
In the Protocol field, select the protocol the FTP server uses (FTP or FTPS (TLS/SSL)).
7-12
Definition
Channel 4 count alarm
Channel 5 count alarm
Channel 6 count alarm
Channel 1 concentration alarm
Channel 2 concentration alarm
.
.
Bit Value Definition
27 134217728 Channel 8 count alarm
28 268435456 Channel 9 count alarm
29 536870912 Channel 10 count alarm
30 1073741824 Channel 11 count alarm
31 2147483648 Channel 12 count alarm
.
EXPORT
DOC026.53.80202, Edition 7