Table of Contents
Advertisement
About Configuration
This section describes tasks that are usually done at the initial commissioning stage. Other tasks are
done as updates to the particle counter are needed.
NOTE
If user passwords are set, the user must be logged in as an administrator to configure the particle
counter.
About Basic and Advanced Operation
At startup, the user can set the operation mode to Basic or Advanced settings.
Use the Basic mode to:
• Do all particle measurement functions
• Save run data in the buffer
Use the Advanced mode to:
• Export data
• Measure air velocity
• Set analog alarms
• Set standards wizards and reports
• Backup, restore and restart
• Copy a configuration
• Set the network protocol (serial, Ethernet, Wi-Fi)
• Manage areas and locations
• Manage user counts and security
• Set user-configurable particle sizes
• Filter data
Set the Operation Mode at Initial Startup
To set the operation mode:
1
Power on the instrument.
DOC026.53.80202, Edition 7
CHAPTER 6
Configuration
6-1
Advertisement
Table of Contents
