How to Use the Print Center
About the Print Center
IMPORTANT
counter must be used without paper, be sure to set the Sample Print Mode field to "None".
The particle counter has a built-in printer. The Print Center screen is accessible from the:
• Counter Navigation screen
• Historical screen
• System Diagnostics screen
• Test/Report Wizard screen
• Area/Location Setup screen
On the Print Center screen, the user can:
• Set automatic print functions
• Print buffer records or count averages
NOTE
Filtered data is printed from the Historical screen.
Print Records Manually
The buffer holds 5000 records maximum. The Print Center can print the entire buffer or the average
of count cycles obtained at each sample point. To print records manually:
1
On the counter Navigation screen, push
2
On the Print Center screen, select the print option for the data. In the Print Report field, select
the regulatory reports that will be printed.
• Push
Refer to
• Push
3
The data will begin to print.
• To cancel the print job, push
• To return to Counter Navigation, push
DOC026.53.80202, Edition 7
To avoid damage to the printer, do not operate the printer without paper. If the particle
to print the average of each size channel for the last sample measurement.
AVERAGE
Figure
7.1.
to print all of the records in the buffer. Refer to
BUFFER
CANCEL PRINT
.
PRINTER
.
.
RETURN
Operation
How to Use the Print Center
Figure
7.2.
7
7-7