Operation
Measure Particle Counts
4
When the count measurement is complete, the test will stop automatically.
Change the Particle Count Location
There are two methods to change the location for a particle count.
• On the Sample screen, push the location name. Select the new location name and confirm.
• On the Sample screen, push the
button to decrement the location.
See Settings During the Particle Count
Location and group settings can be seen at any time during the particle count cycle.
• On the Sample screen, select the Settings tab on the right side of the screen.
See Historical Data During the Particle Count
Historical sample data can be seen at any time during the particle count cycle.
1
On the Sample screen, select the
2
Select the
Use the Filter Scan Probe
IMPORTANT
1
On the Counter Navigation screen, push
2
In the Test screen, push
3
To start the test, push
4
To end the test, push
7-2
PLUS
ARROW
icon to see the data.
HISTORICAL
The filter scan probe function applies to 1 CFM and 50 LPM units only.
.
START FILTER PROBE TEST
STOP FILTER PROBE TEST
button to increment the location, or push the
button.
.
SAMPLE
.
.
MINUS
DOC026.53.80202, Edition 7